[Extreme] Rogers & VPN
Hi!
I an VPN’s Rogers. them are help.
I have client, who remote DSL, Cisco WRV210, another rogers, WRVS4400N 1.1.13.
I created successfully. was well, until ago. went down, replaced with WRV210. VPN,
and wouldn’t connect. Fortunately, a there too, connected that, worked, problems. also
worked, on Bell.
I the factory (it’s Cisco DPC3825) put in mode, and flawlessly again. Now stopped working. I
can’t in clients, and not tunnel. will help, all concerned if surf net.
This is in home, with RVS4000, where to a client, I connect, out, am SMC
Modem/Router.
Here a what getting WRVS4400N.
Feb 22:45:54 – [VPN Log]: Starting (Openswan Version cvs2006Jan12_11:29:56 X.509-1.5.4 PLUTO_SENDS_VENDORID PLUTO_USES_KEYRR; ID
OE@ECqImzhFD)
Feb 21 22:45:55 – [VPN Log]: @(#) built 17 2008:09:38:57:
Feb 21 22:45:55 – [VPN Log]: NAT-Traversal port-4500 to on
Feb 21 22:45:55 – [VPN Log]: floating nat_t=1/port_fload=1
Feb 22:45:55 – [VPN Log]: NAT-Traversal patch (Version 0.6c)
Feb 22:45:55 – [VPN Log]: ike_alg_register_enc(): OAKLEY_AES_CBC: Ok (ret=0)
Feb 21 22:45:55 – [VPN Log]: up helpers
Feb 22:45:55 – [VPN Log]: pid=670 (fd:5)
Feb 21 22:45:55 – [VPN Log]: KLIPS code 2.4.27-star
Feb 22:45:55 – [VPN Log]: Changing ‘/etc/ipsec.d/cacerts’
Feb 22:45:55 – [VPN Log]: directory ‘/etc/ipsec.d/aacerts’
Feb 21 22:45:55 – [VPN Log]: to ‘/etc/ipsec.d/ocspcerts’
Feb 22:45:55 – [VPN Log]: Changing ‘/etc/ipsec.d/crls’
Feb 22:45:55 – [VPN Log]: Warning: directory
Feb 22:45:55 – [VPN Log]: description “k”
Feb 21 22:45:55 – [VPN Log]: for messages
Feb 22:45:55 – [VPN Log]: adding ipsec0/eth1 xxx.xxx.xxx.xxx:500
Feb 22:45:55 – [VPN Log]: ipsec0/eth1 xxx.xxx.xxx.xxx:4500
Feb 21 22:45:55 – [VPN Log]: secrets “/etc/ipsec.secrets”
Feb 22:45:59 – [VPN Log]: “k”: route-client output: 0
Feb 22:45:59 – [VPN Log]: “k” #1: initiating #1, “k”
Feb 22:46:54 – [VPN Log]: packet xxx.xxx.xxx.xxx:500: ignoring ID [4f45725c5b754061666c425f]
Feb 22:46:54 – [VPN Log]: packet xxx.xxx.xxx.xxx:500: received payload [Dead Detection]
Feb 22:46:54 – [VPN Log]: xxx.xxx.xxx.xxx:500: ID [RFC 3947] to=109
Feb 22:46:54 – [VPN Log]: xxx.xxx.xxx.xxx:500: ID [draft-ietf-ipsec-nat-t-ike-03] meth=108, using
method 109
Feb 22:46:54 – [VPN Log]: packet xxx.xxx.xxx.xxx:500: received payload [draft-ietf-ipsec-nat-t-ike-02] meth=107, but
method 109
Feb 21 22:46:54 – [VPN Log]: from xxx.xxx.xxx.xxx:500: Vendor [draft-ietf-ipsec-nat-t-ike-00]
Feb 22:46:54 – [VPN Log]: “k” #2: responding Mode
Feb 22:46:54 – [VPN Log]: “k” #2: transition STATE_MAIN_R0 STATE_MAIN_R1
Feb 22:46:54 – [VPN Log]: “k” #2: STATE_MAIN_R1: MR1, expecting MI2
Feb 21 22:46:54 – [VPN Log]: from xxx.xxx.xxx.xxx:500: informational payload, NO_PROPOSAL_CHOSEN
Feb 22:46:54 – [VPN Log]: xxx.xxx.xxx.xxx:500: ignored message
Feb 22:47:04 – [VPN Log]: packet xxx.xxx.xxx.xxx:500: ignoring payload, type NO_PROPOSAL_CHOSEN
Feb 21 22:47:04 – [VPN Log]: from xxx.xxx.xxx.xxx:500: and message
Feb 22:47:09 – [VPN Log]: “k” #1: max retransmissions (2) STATE_AGGR_I1
Feb 22:47:24 – [VPN Log]: xxx.xxx.xxx.xxx:500: payload, NO_PROPOSAL_CHOSEN
Feb 22:47:24 – [VPN Log]: packet xxx.xxx.xxx.xxx:500: received informational message
Feb 21 22:48:04 – [VPN Log]: “k” #2: of (2) reached STATE_MAIN_R1
Feb 21 22:48:17 – [VPN Log]: on 192.168.1.50:0 192.168.3.5:0 proto=0 state: fos_start because: acquire
Feb 21 22:48:17 – [VPN Log]: “k” #3: Mode #3, “k”
Feb 22:48:17 – [VPN Log]: xxx.xxx.xxx.xxx:500: payload, NO_PROPOSAL_CHOSEN
Feb 22:48:17 – [VPN Log]: packet xxx.xxx.xxx.xxx:500: received informational message
Feb 21 22:48:27 – [VPN Log]: from xxx.xxx.xxx.xxx:500: informational payload, NO_PROPOSAL_CHOSEN
Feb 22:48:27 – [VPN Log]: xxx.xxx.xxx.xxx:500: ignored message
Feb 22:48:47 – [VPN Log]: packet xxx.xxx.xxx.xxx:500: ignoring payload, type NO_PROPOSAL_CHOSEN
Feb 21 22:48:47 – [VPN Log]: from xxx.xxx.xxx.xxx:500: and message
Feb 22:49:27 – [VPN Log]: “k” #3: max retransmissions (2) STATE_AGGR_I1
Feb 22:50:26 – [VPN Log]: xxx.xxx.xxx.xxx:500: Vendor [4f45725c5b754061666c425f]
Feb 22:50:26 – [VPN Log]: xxx.xxx.xxx.xxx:500: ID [Dead Peer Detection]
Feb 21 22:50:26 – [VPN Log]: from xxx.xxx.xxx.xxx:500: Vendor [RFC 3947] set to=109
Feb 21 22:50:26 – [VPN Log]: from xxx.xxx.xxx.xxx:500: Vendor [draft-ietf-ipsec-nat-t-ike-03] meth=108, already
method 109
Feb 22:50:26 – [VPN Log]: xxx.xxx.xxx.xxx:500: ID [draft-ietf-ipsec-nat-t-ike-02] meth=107, using
method 109
Feb 22:50:26 – [VPN Log]: packet xxx.xxx.xxx.xxx:500: received payload [draft-ietf-ipsec-nat-t-ike-00]
And is WRV210
000 [Tue 19:50:21] “TunnelA”: connection
001 [Tue 19:50:21] “TunnelA” #1: state (STATE_MAIN_I1)
002 [Tue 19:50:26] connection “TunnelA”
003 [Tue 19:50:26] “TunnelA” #5: Main Mode
004 [Tue 19:50:26] “TunnelA” #5: [WRV210 Response:] ISAKMP (Main Mode) Initiation
005 [Tue 19:50:26] “TunnelA” #5: Vendor [4f4540454371496d7a684644]
006 [Tue 19:50:26] “TunnelA” #5: received payload [Dead Detection]
007 [Tue 19:50:26] “TunnelA” #5: received payload [RFC 3947] method to=109
008 [Tue 19:50:26] “TunnelA” #5: Can’t authenticate: key `xxx.xxx.xxx.xxx’ `xxx.xxx.xxx.xxx’.
OAKLEY_AUTHENTICATION_METHOD
009 [Tue 19:50:26] “TunnelA” #5: acceptable Transform
010 [Tue 19:50:26] “TunnelA” #5: notification NO_PROPOSAL_CHOSEN xxx.xxx.xxx.xxx:500
011 [Tue 19:50:36] “TunnelA” #5: ignoring ID [4f4540454371496d7a684644]
012 [Tue 19:50:36] “TunnelA” #5: Vendor [Dead Detection]
013 [Tue 19:50:36] “TunnelA” #5: Vendor [RFC 3947] set to=109
014 [Tue 19:50:36] “TunnelA” #5: Can’t authenticate: no found `xxx.xxx.xxx.xxx’ and `xxx.xxx.xxx.xxx’. Attribute
OAKLEY_AUTHENTICATION_METHOD
015 [Tue 19:50:36] “TunnelA” #5: Oakley Transform
016 [Tue 19:50:36] “TunnelA” #5: NO_PROPOSAL_CHOSEN xxx.xxx.xxx.xxx:500
017 [Tue 19:50:56] “TunnelA” #5: unknown payload [4f4540454371496d7a684644]
018 [Tue 19:50:56] “TunnelA” #5: ID [Dead Peer Detection]
019 [Tue 19:50:56] “TunnelA” #5: ID [RFC 3947] to=109
020 [Tue 19:50:56] “TunnelA” #5: Can’t authenticate: preshared for `xxx.xxx.xxx.xxx’ `xxx.xxx.xxx.xxx’.
OAKLEY_AUTHENTICATION_METHOD
021 [Tue 19:50:56] “TunnelA” #5: no Transform
022 [Tue 19:50:56] “TunnelA” #5: sending NO_PROPOSAL_CHOSEN to xxx.xxx.xxx.xxx:500
023 [Tue 19:54:04] from xxx.xxx.xxx.xxx:500: Vendor [Dead Detection]
024 [Tue 19:54:04] packet xxx.xxx.xxx.xxx:500: received payload [RFC 3947] method to=109
025 [Tue 19:54:04] packet xxx.xxx.xxx.xxx:500: received payload [draft-ietf-ipsec-nat-t-ike-03] meth=108, but method 109
026 [Tue 19:54:04] from xxx.xxx.xxx.xxx:500: Vendor [draft-ietf-ipsec-nat-t-ike-02] meth=107, already 109
027 [Tue 19:54:04] xxx.xxx.xxx.xxx:500: ID [draft-ietf-ipsec-nat-t-ike-00]
028 [Tue 19:54:04] “TunnelA” #6: mode is ID_IPV4_ADDR: ‘xxx.xxx.xxx.xxx’
029 [Tue 19:54:04] “TunnelA” #6: to Mode, state #6, “TunnelA” xxx.xxx.xxx.xxx
030 [Tue 19:54:04] “TunnelA” #6: Can’t authenticate: key `xxx.xxx.xxx.xxx’ `xxx.xxx.xxx.xxx’.
OAKLEY_AUTHENTICATION_METHOD
031 [Tue 19:54:04] “TunnelA” #6: acceptable Transform
032 [Tue 19:54:04] “TunnelA” #6: notification NO_PROPOSAL_CHOSEN xxx.xxx.xxx.xxx:500
033 [Tue 19:54:15] xxx.xxx.xxx.xxx:500: ID [Dead Peer Detection]
034 [Tue 19:54:15] from xxx.xxx.xxx.xxx:500: Vendor [RFC 3947] set to=109
035 [Tue 19:54:15] from xxx.xxx.xxx.xxx:500: Vendor [draft-ietf-ipsec-nat-t-ike-03] meth=108, already 109
036 [Tue 19:54:15] xxx.xxx.xxx.xxx:500: ID [draft-ietf-ipsec-nat-t-ike-02] meth=107, using 109
037 [Tue 19:54:15] packet xxx.xxx.xxx.xxx:500: received payload [draft-ietf-ipsec-nat-t-ike-00]
038 [Tue 19:54:15] “TunnelA” #7: peer ID_IPV4_ADDR: ‘xxx.xxx.xxx.xxx’
039 [Tue 19:54:15] “TunnelA” #7: Aggressive Mode, #7, “TunnelA” from xxx.xxx.xxx.xxx
040 [Tue 19:54:15] “TunnelA” #7: Can’t authenticate: no found `xxx.xxx.xxx.xxx’ and `xxx.xxx.xxx.xxx’. Attribute
OAKLEY_AUTHENTICATION_METHOD
041 [Tue 19:54:15] “TunnelA” #7: Oakley Transform
042 [Tue 19:54:15] “TunnelA” #7: NO_PROPOSAL_CHOSEN xxx.xxx.xxx.xxx:500
View full Rogers – dslreports.com community